Just looking for some advice on creating the rubber motor. I'm using a .125 width rubber band, but since there isn't a weight limit on the rubber motor, It's a little unclear to me what weight would be optimal. Right now we've got a 2gram motor, but I was wondering if it would be better to use a heavier motor or if that extra weight would make the helicopter to heavy and just decrease the flight time. Any advice for motor sizes/weight would be appreciated!
So this totally depends on your own helicopter and its performance, there is no perfect flying mass. Adding or reducing weight without changing the width of the rubber band will not effect the torque at any number of turns on your rubber band, only the overall number the motor can hold. Basically, if you are landing with a lot of extra turns at the end of the flight, you might as well cut your motor down (to, say 1.5g to start) to reduce the overall mass of the helicopter and only use the turns you need. On the other hand, if you're basically deadsticking (running out of turns mid-flight), you should definitely increase the weight/length of your motor so you can put more turns on it.