Designs

Locked
twototwenty
Exalted Member
Exalted Member
Posts: 292
Joined: March 24th, 2011, 10:28 am
Division: Grad
State: NY
Has thanked: 0
Been thanked: 0

Designs

Post by twototwenty » August 30th, 2012, 6:39 pm

Discussion regarding helicopter designs

isaysroar
Member
Member
Posts: 78
Joined: November 12th, 2012, 6:22 pm
Division: C
State: PA
Has thanked: 0
Been thanked: 0

Re: Designs

Post by isaysroar » January 13th, 2013, 3:30 pm

I know that a lot of students doing helicopters are using the Parlor Helicopter kit as a good start in renovating their own helicopter design. This is my first year doing Helicopter and by using the kit's instructions I successfully made a working Helicopter. :D
2013
Disease Detectives- 4th
Helicopters- 1st
Road Scholar- 5th
Write it Do it- 2nd

Itsanthonguise
Member
Member
Posts: 26
Joined: December 22nd, 2011, 1:25 pm
Division: B
State: CA
Has thanked: 0
Been thanked: 0

Re: Designs

Post by Itsanthonguise » February 9th, 2013, 8:41 am

I have been using the Freedom Flight Kit, but are there any other designs like mods that can be made on it?
2012 Events
State: Shock Value - 8th place
Nationals: Helicopter Egg Drop - 6th place
2013 Events
Regionals:
Helicopters-2nd place
Rotor Egg Drop-3rd place
State:
Helicopters:-5th place
Rotor Egg Drop-5th place
Nationals:
Helicopters:-17th place
Rotor Egg Drop-46th place

isaysroar
Member
Member
Posts: 78
Joined: November 12th, 2012, 6:22 pm
Division: C
State: PA
Has thanked: 0
Been thanked: 0

Re: Designs

Post by isaysroar » February 26th, 2013, 4:21 pm

That question is kinda confusing do you mean can you make different rotors using the jig already made...then yes. You can make different styles using the same kit over and over again altering different factors like the length of the rotor or the width of the body frame etc. But I probably didn't even answer your question did I?
2013
Disease Detectives- 4th
Helicopters- 1st
Road Scholar- 5th
Write it Do it- 2nd

Locked

Return to “Helicopters B”

Who is online

Users browsing this forum: No registered users and 1 guest