Of course this is not an official clarification, but I see no reason why not. The 1.5cm hole in the middle is the key lid restriction (and the 15 cm limit and the 12cm depth).19sawickin wrote:Can we seal the edge of the lid of the thermo device with tape after putting the lid on while leaving the hole in the middle open? I'm specifically referencing rule 4.d I believe.
Thermodynamics B/C
- Alex-RCHS
- Member
- Posts: 539
- Joined: November 4th, 2016, 3:46 pm
- Division: Grad
- State: NC
- Has thanked: 3 times
- Been thanked: 1 time
Re: Thermodynamics B/C
- Justin72835
- Member
- Posts: 175
- Joined: June 25th, 2017, 7:06 am
- Division: Grad
- State: TX
- Has thanked: 0
- Been thanked: 1 time
Re: Thermodynamics B/C
I agree with Alex-RCHS.Alex-RCHS wrote:Of course this is not an official clarification, but I see no reason why not. The 1.5cm hole in the middle is the key lid restriction (and the 15 cm limit and the 12cm depth).19sawickin wrote:Can we seal the edge of the lid of the thermo device with tape after putting the lid on while leaving the hole in the middle open? I'm specifically referencing rule 4.d I believe.
On the same topic, has anyone else had a ton of trouble with heat escaping from this top hole? I've seen massive drops in temperature when this hole is completely open compared to when it's semi-plugged.
"The fault, dear Brutus, is not in our stars,
But in ourselves, that we are underlings."
University of Texas at Austin '23
Seven Lakes High School '19
But in ourselves, that we are underlings."
University of Texas at Austin '23
Seven Lakes High School '19
-
- Member
- Posts: 37
- Joined: March 29th, 2017, 2:48 pm
- Division: Grad
- State: PA
- Has thanked: 1 time
- Been thanked: 0
Re: Thermodynamics B/C
I am facing the same problem of mass amounts of heat escaping from the water because of the open hole at the top.Justin72835 wrote:I agree with Alex-RCHS.Alex-RCHS wrote:Of course this is not an official clarification, but I see no reason why not. The 1.5cm hole in the middle is the key lid restriction (and the 15 cm limit and the 12cm depth).19sawickin wrote:Can we seal the edge of the lid of the thermo device with tape after putting the lid on while leaving the hole in the middle open? I'm specifically referencing rule 4.d I believe.
On the same topic, has anyone else had a ton of trouble with heat escaping from this top hole? I've seen massive drops in temperature when this hole is completely open compared to when it's semi-plugged.
Eagle View MS (2017-2019)
Cumberland Valley HS (2019-present)
Cumberland Valley HS (2019-present)
-
- Member
- Posts: 35
- Joined: January 16th, 2016, 3:34 pm
- Division: C
- State: NY
- Has thanked: 0
- Been thanked: 0
Re: Thermodynamics B/C
Anyone know the top device scores at MIT? I heard some top teams went for ice bonus
2019:
Mousetrap
Wright Stuff
Sounds
MIT 2018:
Heli: 1st
Mousetrap: 6th
--- Helicopters --- https://youtu.be/nn-x44gB0oA
--- Robot Arm --- https://www.youtube.com/watch?v=gmHcG-bar7w&t=76s
--- Wind Power --- https://www.youtube.com/watch?v=603F7vPUbrg&t=34s
Mousetrap
Wright Stuff
Sounds
MIT 2018:
Heli: 1st
Mousetrap: 6th
--- Helicopters --- https://youtu.be/nn-x44gB0oA
--- Robot Arm --- https://www.youtube.com/watch?v=gmHcG-bar7w&t=76s
--- Wind Power --- https://www.youtube.com/watch?v=603F7vPUbrg&t=34s
-
- Member
- Posts: 108
- Joined: September 29th, 2016, 5:12 pm
- Division: B
- State: NJ
- Has thanked: 0
- Been thanked: 0
Re: Thermodynamics B/C
How close are you guys getting to your actual final temperature with predictions at competitions? Some people are like 0.2 degrees off whereas others are 10-15 degrees off?
What did the thermometer say to the graduated cylinder?
"You may have graduated, but I have many degrees"
"You may have graduated, but I have many degrees"
-
- Member
- Posts: 35
- Joined: January 16th, 2016, 3:34 pm
- Division: C
- State: NY
- Has thanked: 0
- Been thanked: 0
Re: Thermodynamics B/C
At MIT we were 1.2 degrees C low with our prediction.arv101 wrote:How close are you guys getting to your actual final temperature with predictions at competitions? Some people are like 0.2 degrees off whereas others are 10-15 degrees off?
2019:
Mousetrap
Wright Stuff
Sounds
MIT 2018:
Heli: 1st
Mousetrap: 6th
--- Helicopters --- https://youtu.be/nn-x44gB0oA
--- Robot Arm --- https://www.youtube.com/watch?v=gmHcG-bar7w&t=76s
--- Wind Power --- https://www.youtube.com/watch?v=603F7vPUbrg&t=34s
Mousetrap
Wright Stuff
Sounds
MIT 2018:
Heli: 1st
Mousetrap: 6th
--- Helicopters --- https://youtu.be/nn-x44gB0oA
--- Robot Arm --- https://www.youtube.com/watch?v=gmHcG-bar7w&t=76s
--- Wind Power --- https://www.youtube.com/watch?v=603F7vPUbrg&t=34s
-
- Member
- Posts: 14
- Joined: January 23rd, 2018, 6:21 pm
- Division: C
- State: OH
- Has thanked: 0
- Been thanked: 0
Re: Thermodynamics B/C
In my block, the best score was 53.3C internal and 28C external (hrf = 1.903), however, this team did not go for the ice bonusvjindal wrote:Anyone know the top device scores at MIT? I heard some top teams went for ice bonus
- Justin72835
- Member
- Posts: 175
- Joined: June 25th, 2017, 7:06 am
- Division: Grad
- State: TX
- Has thanked: 0
- Been thanked: 1 time
Re: Thermodynamics B/C
Speaking of MIT, what did everyone think about the test? While I thought the multiple choice section was mediocre at best, the free response questions were pretty amazing (despite how difficult that last part was).vjindal wrote:Anyone know the top device scores at MIT? I heard some top teams went for ice bonus
"The fault, dear Brutus, is not in our stars,
But in ourselves, that we are underlings."
University of Texas at Austin '23
Seven Lakes High School '19
But in ourselves, that we are underlings."
University of Texas at Austin '23
Seven Lakes High School '19
-
- Member
- Posts: 14
- Joined: January 23rd, 2018, 6:21 pm
- Division: C
- State: OH
- Has thanked: 0
- Been thanked: 0
Re: Thermodynamics B/C
The last two free response questions were extremely difficult, but super fun to just try even if I had no hope of answering it. I heard the highest score was 90/168 on the test portionJustin72835 wrote:Speaking of MIT, what did everyone think about the test? While I thought the multiple choice section was mediocre at best, the free response questions were pretty amazing (despite how difficult that last part was).vjindal wrote:Anyone know the top device scores at MIT? I heard some top teams went for ice bonus
- Alex-RCHS
- Member
- Posts: 539
- Joined: November 4th, 2016, 3:46 pm
- Division: Grad
- State: NC
- Has thanked: 3 times
- Been thanked: 1 time
Re: Thermodynamics B/C
What was the temperature and volume, if you don’t mind me asking?chopchpp wrote:In my block, the best score was 53.3C internal and 28C external (hrf = 1.903), however, this team did not go for the ice bonusvjindal wrote:Anyone know the top device scores at MIT? I heard some top teams went for ice bonus
Who is online
Users browsing this forum: No registered users and 3 guests