Battery Buggy B

sciolyperson1
Member
Member
Posts: 201
Joined: April 23rd, 2018, 7:13 pm
Division: B
State: NJ

Re: Battery Buggy B

Postby sciolyperson1 » January 31st, 2019, 7:35 pm

ElGuapo wrote:
sciolyperson1 wrote:
MadCow2357 wrote:No need, not like it gives you any significant benefit in doing so. Passing through the cans is one thing, but increasing the length will also increase your weight which is not the best thing.


Of course there's a benefit of a longer buggy. A longer buggy means that you can more precisely measure the starting angle of the buggy, which makes the buggy a lot more accurate.
Increasing the length does increase the weight, but for many, weight doesn't matter much. Weight makes the car go slower, which in turn makes the car more consistent. Skid is also decreased.


Thanks!! I see what you mean. I’m doing fine speed wise. So even if it slows a little I should be ok, I think. How long is your device? I believe there’s been a mention of the length twice on this forum and both devices (including MadCow’s) are 40 cms. Does anyone one have a longer buggy and hows it working out. One of my concerns is that a long buggy’s tail might touch a can while passing through, especially on a ‘sharper’ curve like 9 mts.


A long car will not hit the can, if its curving in a consistent arch (there's no difference). Mine is a bit longer than that, at about 60 cms.

Speaking from experience, my last year's car was the same length as well. We placed 5th at nats, with iirc a perfect distance horizontally (left.right), and off vertically (front/back) by 2.5 cm. This goes to show how longer cars do in fact have benefits.
Community MS (NJ) Captain Dank Memes Area Homeschool
Events
Roller - Boomi - Mystery - Road - Buggy - WIDI - Duct Tape - Parasitology
Medal Count 2019: 18

builder83
Member
Member
Posts: 112
Joined: September 7th, 2017, 4:41 pm
State: -

Re: Battery Buggy B

Postby builder83 » January 31st, 2019, 8:39 pm

ElGuapo wrote:
sciolyperson1 wrote:
MadCow2357 wrote:No need, not like it gives you any significant benefit in doing so. Passing through the cans is one thing, but increasing the length will also increase your weight which is not the best thing.


Of course there's a benefit of a longer buggy. A longer buggy means that you can more precisely measure the starting angle of the buggy, which makes the buggy a lot more accurate.
Increasing the length does increase the weight, but for many, weight doesn't matter much. Weight makes the car go slower, which in turn makes the car more consistent. Skid is also decreased.


Thanks!! I see what you mean. I’m doing fine speed wise. So even if it slows a little I should be ok, I think. How long is your device? I believe there’s been a mention of the length twice on this forum and both devices (including MadCow’s) are 40 cms. Does anyone one have a longer buggy and hows it working out. One of my concerns is that a long buggy’s tail might touch a can while passing through, especially on a ‘sharper’ curve like 9 mts.



Mine is about 65 cm long. Mostly long because of how I wanted to mount my scope and keep frame narrow. No issues with a 20 cm gap. The front wheels and back wheels pass through the cans at the same spot so no tail issue. Unless your wheels are set to the middle and you have a 20 cm spoiler dangling behind your car there shouldn't be an problem :)

User avatar
MadCow2357
Member
Member
Posts: 366
Joined: November 19th, 2017, 9:09 am
Division: B
State: RI
Location: Dank Memes Area Homeschool
Contact:

Re: Battery Buggy B

Postby MadCow2357 » January 31st, 2019, 9:04 pm

sciolyperson1 wrote:Of course there's a benefit of a longer buggy. A longer buggy means that you can more precisely measure the starting angle of the buggy, which makes the buggy a lot more accurate.
Increasing the length does increase the weight, but for many, weight doesn't matter much. Weight makes the car go slower, which in turn makes the car more consistent. Skid is also decreased.

My bad :D forgot about that part. Weight does play a small role in speed, but you are also right in the fact that a slower car will be less prone to skid. I would still maximize my speed though, and use high traction wheels instead to combat the skid.
Last edited by MadCow2357 on February 12th, 2019, 1:11 pm, edited 1 time in total.
MadCow2357's Userpage
2019 Events: Battery Buggy, Boomilever, Fossils, Thermodynamics
"Son, if you really want something in this life, you have to work for it. Now quiet! They're about to announce the lottery numbers!" - Homer Simpson
Rest in peace Balsa Man. You were a great man. :cry:

ElGuapo
Member
Member
Posts: 13
Joined: December 20th, 2018, 7:45 pm

Re: Battery Buggy B

Postby ElGuapo » February 1st, 2019, 5:03 am

builder83 wrote:
ElGuapo wrote:
sciolyperson1 wrote:
Of course there's a benefit of a longer buggy. A longer buggy means that you can more precisely measure the starting angle of the buggy, which makes the buggy a lot more accurate.
Increasing the length does increase the weight, but for many, weight doesn't matter much. Weight makes the car go slower, which in turn makes the car more consistent. Skid is also decreased.


Thanks!! I see what you mean. I’m doing fine speed wise. So even if it slows a little I should be ok, I think. How long is your device? I believe there’s been a mention of the length twice on this forum and both devices (including MadCow’s) are 40 cms. Does anyone one have a longer buggy and hows it working out. One of my concerns is that a long buggy’s tail might touch a can while passing through, especially on a ‘sharper’ curve like 9 mts.



Mine is about 65 cm long. Mostly long because of how I wanted to mount my scope and keep frame narrow. No issues with a 20 cm gap. The front wheels and back wheels pass through the cans at the same spot so no tail issue. Unless your wheels are set to the middle and you have a 20 cm spoiler dangling behind your car there shouldn't be an problem :)


Thanks!!

Just checking... I thought the maximum length allowed was 60 cms...or did I get that wrong...

ElGuapo
Member
Member
Posts: 13
Joined: December 20th, 2018, 7:45 pm

Re: Battery Buggy B

Postby ElGuapo » February 1st, 2019, 5:04 am

sciolyperson1 wrote:
ElGuapo wrote:
sciolyperson1 wrote:
Of course there's a benefit of a longer buggy. A longer buggy means that you can more precisely measure the starting angle of the buggy, which makes the buggy a lot more accurate.
Increasing the length does increase the weight, but for many, weight doesn't matter much. Weight makes the car go slower, which in turn makes the car more consistent. Skid is also decreased.


Thanks!! I see what you mean. I’m doing fine speed wise. So even if it slows a little I should be ok, I think. How long is your device? I believe there’s been a mention of the length twice on this forum and both devices (including MadCow’s) are 40 cms. Does anyone one have a longer buggy and hows it working out. One of my concerns is that a long buggy’s tail might touch a can while passing through, especially on a ‘sharper’ curve like 9 mts.


A long car will not hit the can, if its curving in a consistent arch (there's no difference). Mine is a bit longer than that, at about 60 cms.

Speaking from experience, my last year's car was the same length as well. We placed 5th at nats, with iirc a perfect distance horizontally (left.right), and off vertically (front/back) by 2.5 cm. This goes to show how longer cars do in fact have benefits.


Thanks for sharing! This does help!

builder83
Member
Member
Posts: 112
Joined: September 7th, 2017, 4:41 pm
State: -

Re: Battery Buggy B

Postby builder83 » February 1st, 2019, 5:21 am

ElGuapo wrote:
builder83 wrote:
ElGuapo wrote:
Thanks!! I see what you mean. I’m doing fine speed wise. So even if it slows a little I should be ok, I think. How long is your device? I believe there’s been a mention of the length twice on this forum and both devices (including MadCow’s) are 40 cms. Does anyone one have a longer buggy and hows it working out. One of my concerns is that a long buggy’s tail might touch a can while passing through, especially on a ‘sharper’ curve like 9 mts.



Mine is about 65 cm long. Mostly long because of how I wanted to mount my scope and keep frame narrow. No issues with a 20 cm gap. The front wheels and back wheels pass through the cans at the same spot so no tail issue. Unless your wheels are set to the middle and you have a 20 cm spoiler dangling behind your car there shouldn't be an problem :)


Thanks!!

Just checking... I thought the maximum length allowed was 60 cms...or did I get that wrong...


There is no max length for your buggy. But the wheels need to fit inside 60cm length.

Crimesolver
Member
Member
Posts: 42
Joined: July 31st, 2018, 2:07 pm
Division: B
State: CA

Re: Battery Buggy B

Postby Crimesolver » February 1st, 2019, 10:08 am

Any tips on going for the bonus? I'm using as protractor, but it's not getting accurate enough. My device is also too big for a caliper. Should I use a sighting device?????????????? So stressed sdlijhglkajsh
Current Events
Crime Busters 3rd
Thermodynamics 4th
Circuit Lab 4th
Potions and Poisons 5th
Battery Buggy what a failure


Finished regionals, going to states :cry: :shock: :lol:

builder83
Member
Member
Posts: 112
Joined: September 7th, 2017, 4:41 pm
State: -

Re: Battery Buggy B

Postby builder83 » February 1st, 2019, 2:37 pm

Crimesolver wrote:Any tips on going for the bonus? I'm using as protractor, but it's not getting accurate enough. My device is also too big for a caliper. Should I use a sighting device?????????????? So stressed sdlijhglkajsh


I would bet most people trying to be super accurate use a sighting device or scope yes.

User avatar
MadCow2357
Member
Member
Posts: 366
Joined: November 19th, 2017, 9:09 am
Division: B
State: RI
Location: Dank Memes Area Homeschool
Contact:

Re: Battery Buggy B

Postby MadCow2357 » February 11th, 2019, 1:40 pm

Anybody know whether spinning the axle connected to the motor while winding the buggy will damage it?
MadCow2357's Userpage
2019 Events: Battery Buggy, Boomilever, Fossils, Thermodynamics
"Son, if you really want something in this life, you have to work for it. Now quiet! They're about to announce the lottery numbers!" - Homer Simpson
Rest in peace Balsa Man. You were a great man. :cry:

rabbitman
Member
Member
Posts: 6
Joined: September 12th, 2018, 4:45 pm
State: -

Re: Battery Buggy B

Postby rabbitman » February 11th, 2019, 4:15 pm

MadCow2357 wrote:Anybody know whether spinning the axle connected to the motor while winding the buggy will damage it?

its a dc motor lol what do you think will happen

sciolyperson1
Member
Member
Posts: 201
Joined: April 23rd, 2018, 7:13 pm
Division: B
State: NJ

Re: Battery Buggy B

Postby sciolyperson1 » February 11th, 2019, 6:04 pm

MadCow2357 wrote:Anybody know whether spinning the axle connected to the motor while winding the buggy will damage it?


Nothing will happen.
Community MS (NJ) Captain Dank Memes Area Homeschool
Events
Roller - Boomi - Mystery - Road - Buggy - WIDI - Duct Tape - Parasitology
Medal Count 2019: 18


Return to “Battery Buggy B”

Who is online

Users browsing this forum: No registered users and 1 guest