Materials
- MadCow2357
- Exalted Member
- Posts: 774
- Joined: November 19th, 2017, 9:09 am
- Division: C
- State: RI
- Has thanked: 211 times
- Been thanked: 56 times
- Contact:
-
- Member
- Posts: 1
- Joined: December 9th, 2019, 12:10 pm
- Division: B
- State: RI
- Has thanked: 0
- Been thanked: 0
Re: Materials
Are we allowed to 3D print parts of the mousetrap's base to act as a slip-on? Our team researched for a while but we couldn't find an answer.
Re: Materials
What is a slip-on? If you mean print a mount that holds the trap, that would be fine as long as you do not modify the trap.Zackariah! wrote: ↑December 9th, 2019, 12:14 pm Are we allowed to 3D print parts of the mousetrap's base to act as a slip-on? Our team researched for a while but we couldn't find an answer.
Who is online
Users browsing this forum: No registered users and 1 guest