- Posts: 12
- Joined: January 25th, 2020, 9:19 am
- Division: B
- State: NC
- Has thanked: 0
- Been thanked: 0
- Posts: 372
- Joined: February 15th, 2018, 5:05 pm
- Division: C
- State: NJ
- Location: Am I here? Or there? Or both...?
- Has thanked: 32 times
- Been thanked: 10 times
I prefer using a circular parachute. this means that you can just keep folding a sheet of material around a centerpoint over and over until it becomes pretty narrow and you can just cut across your desired radius. This will be pretty much a circular parachute. If you're going for octagonal, i think that nerds inc sells a guide but don't quote me on that.
2020 Events: Protein Modeling, Ping Pong Parachute, Wright Stuff, Sounds of Music
Reality is merely an illusion, albeit a very persistent one.
Check out my userpage!
Users browsing this forum: No registered users and 1 guest