Creation Of The Lever
-
- Member
- Posts: 8
- Joined: December 31st, 2019, 2:54 pm
- Division: C
- State: MD
- Has thanked: 0
- Been thanked: 0
Re: Creation Of The Lever
Thanks so much! Could you make your diagram accessible, because I have to request access. Thanks again
-
- Member
- Posts: 10
- Joined: November 11th, 2019, 9:06 am
- Division: C
- State: NY
- Has thanked: 0
- Been thanked: 0
Re: Creation Of The Lever
https://drive.google.com/open?id=1g9FkW ... 4ChCY2lJxo
Here's the new link. The counterweight is excluded from the diagram for simplicity purposes.
Here's the new link. The counterweight is excluded from the diagram for simplicity purposes.
Is it called success if you never failed?
Hicksville High School Class of ‘22
Hicksville High School Class of ‘22
-
- Member
- Posts: 8
- Joined: December 31st, 2019, 2:54 pm
- Division: C
- State: MD
- Has thanked: 0
- Been thanked: 0
Re: Creation Of The Lever
I really want to thank you for your time helping me and hopefully others who will read this, you helped save my build!
Thanks so much
Thanks so much
-
- Member
- Posts: 123
- Joined: November 2nd, 2017, 5:15 pm
- Division: Grad
- State: VA
- Pronouns: He/Him/His
- Has thanked: 27 times
- Been thanked: 32 times
- Contact:
Re: Creation Of The Lever
What steps have you all taken to improve consistency? I've been prototyping and testing different designs and materials lately, and none of them have been particularly reliable. Have any of you found or done something that causes your machine to work correctly (be accurate) pretty often?
Also, am I the only one who's had a bad experience with metal? It seems that every time I try experimenting with metal rods for my levers, the device accuracy plunges. Could that be due to the greater mass of the metal, or is there something else I'm missing? Strangely, the best levers in my experience seem to be wood rulers from Staples.
Also, am I the only one who's had a bad experience with metal? It seems that every time I try experimenting with metal rods for my levers, the device accuracy plunges. Could that be due to the greater mass of the metal, or is there something else I'm missing? Strangely, the best levers in my experience seem to be wood rulers from Staples.
TJHSST '22 | UVA '26
smayya337's Userpage
smayya337's Userpage
Who is online
Users browsing this forum: No registered users and 1 guest