Rule clarification: Size of the beam/leverl

Locked
boutanit
Member
Member
Posts: 1
Joined: March 8th, 2020, 10:55 pm
Division: B
State: CA
Has thanked: 0
Been thanked: 0

Rule clarification: Size of the beam/leverl

Post by boutanit » March 8th, 2020, 11:07 pm

Hi-
The first rule was repeated many times:
Ensure device fits into the bound box, 1m x 1m x 0.5m
But then I recently notice this second rule in the slides:
Ensure Division B Beam is less than 80cm no matter how measured (include anything on the ends)
Is the beam = "lever end to end" or "from fulcrum to end"?
I am pretty sure it is the former, but it means we have to redo our lever, so I wanted to double check.
If the beam = lever end to end, then the box seems overdimensioned. I understand people can go crazy with the support etc...

Locked

Return to “Machines B/C”

Who is online

Users browsing this forum: No registered users and 1 guest