It will be up to whoever is running the event to define what is acceptable. When we did a practice build, the goal was to fit a tennis ball through the tunnel. I put it on a dowel to make it easy to test by passing it through.waffletree wrote:maybe like if the hole is big enough to stick like...a 1/4 dowel rod it in then its not a tunnel? or maybe it has to be entirely enclosed?builderguy135 wrote:Define "enclosed". How "enclosed" does it have to be for it to be considered a tunnel? Can there be holes in the tunnel?waffletree wrote: idek.........i thought that maybe you have to build an enclosed structure where you have to be able to roll a ball through it? i may be wrong...
yea no i have no idea
Mystery Architecture B
Re: Mystery Architecture B
-
- Member
- Posts: 2
- Joined: February 4th, 2019, 1:50 pm
- Has thanked: 0
- Been thanked: 0
Re: Mystery Architecture B
I have a question regarding "rules". Someone said that the rules seem vague. Does that mean there are actual rules published somewhere? Is anything published anywhere for this event?
-
- Member
- Posts: 637
- Joined: April 26th, 2018, 6:40 pm
- Has thanked: 4 times
- Been thanked: 110 times
Re: Mystery Architecture B
The rules manuals are available from the Science Olympiad store at https://store.soinc.org/us/page/manualsvolunteerDad wrote:I have a question regarding "rules". Someone said that the rules seem vague. Does that mean there are actual rules published somewhere? Is anything published anywhere for this event?
There is no charge to obtain a copy of the rules, but please read the terms under which the rules are made available and follow them.
At each competition, the Event Supervisor will give instructions for the build - what structure needs to be built, how it will be tested, and how it will be scored. Competitors should read these instructions carefully...
- Crimesolver
- Member
- Posts: 111
- Joined: July 31st, 2018, 2:07 pm
- Division: C
- State: CA
- Pronouns: She/Her/Hers
- Has thanked: 6 times
- Been thanked: 22 times
Re: Mystery Architecture B
I don't personally do MA but, according to my friends, it has to be FULLY enclosed. However, the diameter of the tunnel depends on, what they've seen, the size of the ball that will pass through the tunnel.heiber wrote:It will be up to whoever is running the event to define what is acceptable. When we did a practice build, the goal was to fit a tennis ball through the tunnel. I put it on a dowel to make it easy to test by passing it through.waffletree wrote:maybe like if the hole is big enough to stick like...a 1/4 dowel rod it in then its not a tunnel? or maybe it has to be entirely enclosed?builderguy135 wrote:
Define "enclosed". How "enclosed" does it have to be for it to be considered a tunnel? Can there be holes in the tunnel?
yea no i have no idea
- Crimesolver
- Member
- Posts: 111
- Joined: July 31st, 2018, 2:07 pm
- Division: C
- State: CA
- Pronouns: She/Her/Hers
- Has thanked: 6 times
- Been thanked: 22 times
Re: Mystery Architecture B
I don't personally do MA but, according to my friends, it has to be FULLY enclosed. However, the diameter of the tunnel depends on, what they've seen, the size of the ball that will pass through the tunnel.heiber wrote:It will be up to whoever is running the event to define what is acceptable. When we did a practice build, the goal was to fit a tennis ball through the tunnel. I put it on a dowel to make it easy to test by passing it through.waffletree wrote:maybe like if the hole is big enough to stick like...a 1/4 dowel rod it in then its not a tunnel? or maybe it has to be entirely enclosed?builderguy135 wrote:
Define "enclosed". How "enclosed" does it have to be for it to be considered a tunnel? Can there be holes in the tunnel?
yea no i have no idea
- builderguy135
- Exalted Member
- Posts: 736
- Joined: September 8th, 2018, 12:24 pm
- Division: C
- State: NJ
- Pronouns: He/Him/His
- Has thanked: 191 times
- Been thanked: 143 times
- Contact:
Re: Mystery Architecture B
The definition of "fully enclosed" can significantly vary from supervisor to supervisor.Crimesolver wrote:I don't personally do MA but, according to my friends, it has to be FULLY enclosed. However, the diameter of the tunnel depends on, what they've seen, the size of the ball that will pass through the tunnel.heiber wrote:It will be up to whoever is running the event to define what is acceptable. When we did a practice build, the goal was to fit a tennis ball through the tunnel. I put it on a dowel to make it easy to test by passing it through.waffletree wrote: maybe like if the hole is big enough to stick like...a 1/4 dowel rod it in then its not a tunnel? or maybe it has to be entirely enclosed?
yea no i have no idea
-
- Member
- Posts: 1
- Joined: February 8th, 2019, 12:17 pm
- Division: B
- State: NY
- Has thanked: 0
- Been thanked: 0
Re: Mystery Architecture B
For a cantilever, what kind do they mean, and what are some examples of a fulcrum and a support? Can it be attached to a table and hang off the edge? Also, what are some good ways to practice for this event? Thank you.
-
- Member
- Posts: 10
- Joined: November 8th, 2018, 3:03 pm
- Division: B
- State: NY
- Has thanked: 0
- Been thanked: 0
Re: Mystery Architecture B
For a cantilever, it would be a bridge like structure that holds a weight at one end, and a counter balance on the other. A fulcrum is used to go under the bridge-like structure.sophhehehe12 wrote:For a cantilever, what kind do they mean, and what are some examples of a fulcrum and a support? Can it be attached to a table and hang off the edge? Also, what are some good ways to practice for this event? Thank you.
Some examples of a fulcrum would be an 8 ounce cup, or try making your own because not all competitions provide fulcrums.
It cannot be attached to the table because it must be free-standing.
The best way to practice is to try to use different materials, such as paper, Popsicle sticks, straws, tape, rubber bands, etc. Practice using a provided fulcrum and without a provided fulcrum.
Hope this helps!
-
- Member
- Posts: 6
- Joined: September 23rd, 2017, 11:05 am
- Division: B
- State: NY
- Has thanked: 0
- Been thanked: 0
- Contact:
Re: Mystery Architecture B
A cantilever is a structure that has a fulcrum and extends out to one side. it's like a bridge with one base or support. the last time my team and I had to build a cantilever, we had the table as a fulcrum. it cannot be attached to the table. from what I know.sophhehehe12 wrote:For a cantilever, what kind do they mean, and what are some examples of a fulcrum and support? Can it be attached to a table and hang off the edge? Also, what are some good ways to practice for this event? Thank you.
-
- Member
- Posts: 90
- Joined: April 29th, 2017, 3:53 pm
- Division: B
- State: NY
- Has thanked: 0
- Been thanked: 7 times
Re: Mystery Architecture B
Greetings my fellow Mystery Architecture legends, if you want some practice and see how you compare to other teams, below is a link for a practice prompt made by our good friends over at Community. Feel free to add your score if you choose to participate. Good luck and have fun.
https://docs.google.com/document/d/1fPD ... grM-c/edit
https://docs.google.com/document/d/1fPD ... grM-c/edit
Circuit Lab NY State Champion with legendary circuitologist Eric Wang
LONGEST DEFENDING ROCKS AND MINERALS REGIONAL CHAMPION OF EASTERN LONG ISLAND IN HISTORY ~4 YEARS AND COUNTING
LONGEST DEFENDING ROCKS AND MINERALS REGIONAL CHAMPION OF EASTERN LONG ISLAND IN HISTORY ~4 YEARS AND COUNTING
Who is online
Users browsing this forum: No registered users and 3 guests