oh yeah. i've seen those before. the person who was showing it to me said it was some good stuff. never tired it personaly though. too bad they dont make them anymore.I will try to post an image of the Geauga prop hanger again in this thread. If you can't see it go to the Image Gallery.
The diameter is measured straight across the axis. At nationals they have a slot that is 20cm wide that you have to fit your prop through.How is the diameter of the propeller measured? Straight across the axis along the spar or from far tip to far tip?
I depends on how you bent your prop wire. The easiest way to figure out how to remove a prop from a pigtail bearing is to put the prop so that the rounded section where the oring goes is right against the pigtail and then rotate the wire while pulling lightly on the prop. If the wire is bent right it should come right out. Could you post a picture of your current set up? Sometimes it can be pretty tricky to get out if you are using larger diameter wire.I'm not understanding how you can remove your propeller from the pigtail prop hanger. If anyone has it, could they post a picture?
Users browsing this forum: No registered users and 1 guest