MagLev Vehicle B/C

Locked
twototwenty
Exalted Member
Exalted Member
Posts: 292
Joined: March 24th, 2011, 10:28 am
Division: Grad
State: NY
Has thanked: 0
Been thanked: 0

Re: MagLev Vehicle B/C

Post by twototwenty »

It was literally two shorter tracks, lined up and held in place by two pieces of tape, one on either side. The was a small lip at the joint, and it affected most cars saw that made it that far. A lot of cars didnt make it that far; they didnt move at all because the track was smaller than those teams' school's tracks, which brings us back to the other issue.
arugi
Member
Member
Posts: 9
Joined: January 5th, 2011, 6:42 pm
Division: C
State: NY
Has thanked: 0
Been thanked: 0
Contact:

Re: MagLev Vehicle B/C

Post by arugi »

Does anyone have any idea on what to use to create a mock sled for the MagLev? I tried foam, but it isn't standing up too well, especially under over 150g weights.
It's the week before the competition... Look forward to seeing all of you at SUNY!
Johnny was a chemist's son, but Johnny is no more. What Johnny thought was H2O was H2SO4.
Johnny should have joined Science Olympiad.
User avatar
Primate
Member
Member
Posts: 409
Joined: January 15th, 2009, 4:34 pm
Division: C
State: NY
Has thanked: 0
Been thanked: 0

Re: MagLev Vehicle B/C

Post by Primate »

arugi wrote:Does anyone have any idea on what to use to create a mock sled for the MagLev? I tried foam, but it isn't standing up too well, especially under over 150g weights.
It's the week before the competition... Look forward to seeing all of you at SUNY!
Tupperware. See if you can find one that just fits between the rails, then just position the magnets. Using sand as your weight is a great way to keep it balanced.
events 2012 gravity vehicle, robot arm, thermodynamics, tps
mxz55o
Member
Member
Posts: 5
Joined: February 23rd, 2011, 7:54 am
Division: B
State: MA
Has thanked: 0
Been thanked: 0

Re: MagLev Vehicle B/C

Post by mxz55o »

I am a new coach for this trial event and need to order the track. I see from the NY site (http://www.newyorkscioly.org/SOPages/COTResources.html) which the MagLev Science Olympiad description points to says that there are both Kelvin and Pitsco tracks but Pitsco moved their magnets.

Who is the manufacture of the tracks which will be at nationals? Does anybody know so I can make sure I order the right ones.

Thanks.
ryang353
Member
Member
Posts: 5
Joined: April 5th, 2011, 4:35 pm
Division: C
State: VA
Has thanked: 0
Been thanked: 0

Re: MagLev Vehicle B/C

Post by ryang353 »

Are rechargeable 9 volt batteries allowed in the MagLev trial event in Wisc? It doesn't state they are not. Thank you!
User avatar
Primate
Member
Member
Posts: 409
Joined: January 15th, 2009, 4:34 pm
Division: C
State: NY
Has thanked: 0
Been thanked: 0

Re: MagLev Vehicle B/C

Post by Primate »

ryang353 wrote:Are rechargeable 9 volt batteries allowed in the MagLev trial event in Wisc? It doesn't state they are not. Thank you!
I believe you could actually use any type of battery that outputs 9V. (Granted, you might want to stay away from something weird and dangerous like this.) As long as it looks like a 9V and says "9V" on the outside, you should be good to go.

(Never a bad idea to bring a couple alkalines as backup.)

Also, mxz55o, you don't have much choice if you're buying a new track, right? The new Pitsco ones don't match specs, so you have to go with the Kelvin ones. They'll most likely use those at nationals, too--unless someone had an old set of Pitscos lying around.
events 2012 gravity vehicle, robot arm, thermodynamics, tps
ryang353
Member
Member
Posts: 5
Joined: April 5th, 2011, 4:35 pm
Division: C
State: VA
Has thanked: 0
Been thanked: 0

Re: MagLev Vehicle B/C

Post by ryang353 »

I recommend three pronged propellers. These seem to preform the best, however, they begin to get inefficient after their diameter gets over 4-5 inches. Btw, does anyone know if rechargeable nine volt batteries are allowed?
User avatar
Jocool
Member
Member
Posts: 269
Joined: December 23rd, 2008, 8:17 pm
Division: C
State: NY
Has thanked: 0
Been thanked: 0
Contact:

Re: MagLev Vehicle B/C

Post by Jocool »

Rechargeable 9 volt batteries are not allowed.
Go to Jocool's Userpage for my results.

Halo Series Fan
Male.
Assassinator #22.
C.P. Weber Scioly Team Rule #42: BLAME TEAM 3
User avatar
Primate
Member
Member
Posts: 409
Joined: January 15th, 2009, 4:34 pm
Division: C
State: NY
Has thanked: 0
Been thanked: 0

Re: MagLev Vehicle B/C

Post by Primate »

Jocool wrote:Rechargeable 9 volt batteries are not allowed.
Where does it say that?
events 2012 gravity vehicle, robot arm, thermodynamics, tps
User avatar
Jocool
Member
Member
Posts: 269
Joined: December 23rd, 2008, 8:17 pm
Division: C
State: NY
Has thanked: 0
Been thanked: 0
Contact:

Re: MagLev Vehicle B/C

Post by Jocool »

I am mistaken. That was a Car of Tomorrow rule that did not carry over into MagLev.
Go to Jocool's Userpage for my results.

Halo Series Fan
Male.
Assassinator #22.
C.P. Weber Scioly Team Rule #42: BLAME TEAM 3
Locked

Return to “2011 Build Events”

Who is online

Users browsing this forum: No registered users and 1 guest