Sounds Of Music C

 Member
 Posts: 6
 Joined: June 29th, 2018, 9:51 am
 Has thanked: 0
 Been thanked: 0
Sounds Of Music C
Welcome to the 20182019 season! I'll start with some basics:
A speaker produces a sound with an intensity of 1 x 10^4 W/m^2. What is the intensity, in decibels, of the sound produced by 4 of these speakers?
A speaker produces a sound with an intensity of 1 x 10^4 W/m^2. What is the intensity, in decibels, of the sound produced by 4 of these speakers?

 Member
 Posts: 121
 Joined: May 9th, 2014, 3:34 am
 Division: Grad
 State: VA
 Has thanked: 0
 Been thanked: 0
Re: Sounds Of Music C
10^4 W/m^2 is 80dB. A factor of 4 is an additional 6dB, so the configuration has a total sound intensity of 86dB (assuming only constructive interference).
MIT ‘23
TJHSST ‘19
Longfellow MS
See my user page for nationals medals and event supervising experience.
TJHSST ‘19
Longfellow MS
See my user page for nationals medals and event supervising experience.
Re: Sounds Of Music C
Hi there, here is my answer:
forgive my formatting
Here is my question : A soprano saxophone is considered an open pipe resonator. If the pipe was straightened
out it would be 65 cm long. Using 343 m/s for the speed of sound, find the lowest
frequency that can be played, ignoring end corrections.
A wee bit word problem
forgive my formatting
dB = 10 log I / I (threshold intensity ) = 10 log 4(1 x 10^4 W/m^2) / 1 x 10^12 W/m^2 = 86dB, so final is 86dB
out it would be 65 cm long. Using 343 m/s for the speed of sound, find the lowest
frequency that can be played, ignoring end corrections.
A wee bit word problem

 Member
 Posts: 6
 Joined: June 29th, 2018, 9:51 am
 Has thanked: 0
 Been thanked: 0
Re: Sounds Of Music C
So the fundamental frequency is equal to 2/1 Length. 65 cm * 2 = 130. 343 m/s = 1.3 m * frequency. After calculating, I got ~364 Hz.goblinrum wrote:Hi there, here is my answer:
forgive my formattingHere is my question : A soprano saxophone is considered an open pipe resonator. If the pipe was straighteneddB = 10 log I / I (threshold intensity ) = 10 log 4(1 x 10^4 W/m^2) / 1 x 10^12 W/m^2 = 86dB, so final is 86dB
out it would be 65 cm long. Using 343 m/s for the speed of sound, find the lowest
frequency that can be played, ignoring end corrections.
A wee bit word problem

 Member
 Posts: 6
 Joined: June 29th, 2018, 9:51 am
 Has thanked: 0
 Been thanked: 0
Re: Sounds Of Music C
Sorry, forgot to tell you that you got the correct answer on my questionDarkmatter7 wrote:So the fundamental frequency is equal to 2/1 Length. 65 cm * 2 = 130. 343 m/s = 1.3 m * frequency. After calculating, I got ~364 Hz.goblinrum wrote:Hi there, here is my answer:
forgive my formattingHere is my question : A soprano saxophone is considered an open pipe resonator. If the pipe was straighteneddB = 10 log I / I (threshold intensity ) = 10 log 4(1 x 10^4 W/m^2) / 1 x 10^12 W/m^2 = 86dB, so final is 86dB
out it would be 65 cm long. Using 343 m/s for the speed of sound, find the lowest
frequency that can be played, ignoring end corrections.
A wee bit word problem
Re: Sounds Of Music C
Did you just do (343 m/s) / 1.3 m is 364Hz????Darkmatter7 wrote:Sorry, forgot to tell you that you got the correct answer on my questionDarkmatter7 wrote:So the fundamental frequency is equal to 2/1 Length. 65 cm * 2 = 130. 343 m/s = 1.3 m * frequency. After calculating, I got ~364 Hz.goblinrum wrote:Hi there, here is my answer:
forgive my formattingHere is my question : A soprano saxophone is considered an open pipe resonator. If the pipe was straighteneddB = 10 log I / I (threshold intensity ) = 10 log 4(1 x 10^4 W/m^2) / 1 x 10^12 W/m^2 = 86dB, so final is 86dB
out it would be 65 cm long. Using 343 m/s for the speed of sound, find the lowest
frequency that can be played, ignoring end corrections.
A wee bit word problem

 Member
 Posts: 3
 Joined: September 5th, 2018, 3:55 pm
 Division: C
 State: TX
 Has thanked: 0
 Been thanked: 0
Re: Sounds Of Music C
I think you might be wrong or I might be wrongDarkmatter7 wrote:So the fundamental frequency is equal to 2/1 Length. 65 cm * 2 = 130. 343 m/s = 1.3 m * frequency. After calculating, I got ~364 Hz.goblinrum wrote:Hi there, here is my answer:
forgive my formattingHere is my question : A soprano saxophone is considered an open pipe resonator. If the pipe was straighteneddB = 10 log I / I (threshold intensity ) = 10 log 4(1 x 10^4 W/m^2) / 1 x 10^12 W/m^2 = 86dB, so final is 86dB
out it would be 65 cm long. Using 343 m/s for the speed of sound, find the lowest
frequency that can be played, ignoring end corrections.
A wee bit word problem
Freq= speed/wavelength F= 343 /(2*.65meters)= 263.846 or 264 Hz.

 Member
 Posts: 6
 Joined: June 29th, 2018, 9:51 am
 Has thanked: 0
 Been thanked: 0
Re: Sounds Of Music C
264Hz. I miss typed .goblinrum wrote:Did you just do (343 m/s) / 1.3 m is 364Hz????Darkmatter7 wrote:Sorry, forgot to tell you that you got the correct answer on my questionDarkmatter7 wrote: So the fundamental frequency is equal to 2/1 Length. 65 cm * 2 = 130. 343 m/s = 1.3 m * frequency. After calculating, I got ~364 Hz.

 Member
 Posts: 6
 Joined: June 29th, 2018, 9:51 am
 Has thanked: 0
 Been thanked: 0
Re: Sounds Of Music C
A Solid has a bulk modulus of 2.3 × 10^7 N/m^2 and a density of 8.05 g/cm^3. What is the speed of sound in this solid?

 Member
 Posts: 5
 Joined: June 17th, 2017, 3:16 pm
 Has thanked: 0
 Been thanked: 0
Re: Sounds Of Music C
Using the equation for speed of sound in a medium, V = sqrt(B/R), where B is the Bulk Modulus and R is rho, the density of the material.
Let's plug in the variables: sqrt((2.3*10^7)/(8.05*(10^3))) (converting density to metric units), which gives us 2857 m/s (if I didn't somehow mess up the calculation.
Let's plug in the variables: sqrt((2.3*10^7)/(8.05*(10^3))) (converting density to metric units), which gives us 2857 m/s (if I didn't somehow mess up the calculation.
Who is online
Users browsing this forum: No registered users and 0 guests