Taring In-Between Measurements

Locked
kenntnisse
Member
Member
Posts: 16
Joined: December 2nd, 2022, 7:56 pm
Division: C
State: WA
Pronouns: He/Him/His
Has thanked: 2 times
Been thanked: 0

Taring In-Between Measurements

Post by kenntnisse »

My detector has issues with multiple measurements in succession, i.e. some of the strain is retained between measurements.

The Arduino Uno I'm using has this reset button on the board, allowing me to rerun the program and tare the device again.

I don't think there is anything in the rules against that, but just for confirmation, can I press that button to restart the program (and tare the device) before measuring each time?

And I do have enough time to restart the program and measure the mass in one minute, so no worries about that.
knightmoves
Member
Member
Posts: 632
Joined: April 26th, 2018, 6:40 pm
Has thanked: 4 times
Been thanked: 108 times

Re: Taring In-Between Measurements

Post by knightmoves »

You have one minute to measure each sample. Restarting code, taking a zero sample etc. all seem to be reasonable things you could chose to do in that minute.
These users thanked the author knightmoves for the post:
kenntnisse (April 3rd, 2023, 4:07 pm)
Locked

Return to “Detector Building C”

Who is online

Users browsing this forum: No registered users and 0 guests