Home > Past Build Events > MagLev
 
Click to view full size image

MagLev car, 2014

This is for the cage. It's 1/8'' wire mesh "sewed" together to make a cage. There is copper wire as the connecting wire, used in a looping fashion to hold together the mesh pieces. Once built, the propellor shaft went on one side, and we put and attached the propeller to the inside, so we had the rule about not being able to touch the propeller safely covered

 
maglev_trial.png
MagLev~0.jpg
MagLev~1.jpg
 
Designed by STSoftware, converted for Coppermine Gallery 1.5.x by PortalXL Group © 2010